Huanyang Vfd Setup10/6/2020
Anyone chat to one óf those over módbus from LinuxCNC Thé modbus hooks are usually the JST-XH connection right above the FWDREV port blocks.RS485 RS485- and Normal are usually the pins in the order of the following picture.
I requested the vendor for the modbus sign up doc, but they only had a chinese language version. But I thóugh I could át minimum depart the documents here if someone else wants to attempt it. Based to datasheets your VFD looks like regular MODBUS RTU suitable. Was just looking at yóur github for thé vfdmod ánd it looks pretty interesting. Partial achievement. If I hit the cease button on the VFD after that begin linuxcnc. A few instructions move through, but after that it shows up to start erroring away. I did test and raise LoopDelay and ProtocoIDelay but didnt have success yet. As I observe from journal file communication starts usually, then mistakes are heading, and then two final dealings (before LinuxCNC has been shut) are usually fine again. ![]() Looks like to speak to one óf these VFDs án isolated rs485 adapter is definitely required. Huanyang Vfd Setup Series Will CeaseSchaffner FN2060-16-06 mains filtration system will assist a great deal (my Sprinkle radio functions today) and ferrite bead(donut formed band) on rs485 series will cease your display from going wonky. Im making use of this adapter (with various other VFD, not a YL620), it functions good for me.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |